EEC 214(ELETRONICS) SOLVED PAST QUESTION

Electronics two solved past question for first semester ND2 EEC 214

1. DEFINE THE FOLLOWING TERMS
2. D.C LOAD LINE: The straight line joining it cut off point with the saturation point is known as D.C load line.
3. A.C LOAD LINE: It’s the line in which the quiescent point sift up and down, when changes in the output voltage and current is caused by the A.C signal
4. STATE THREE TRANSISTOR CONFIGURATION YOU KNOW
5. Common base CB
6. Common emitter CE
7. Common collector CC

For more study check the link below DC and AC loadline

• STATE THE MODES OF OPERARATION OF A BJT BIASING OPERATION OF THE JUNCTION
• Cut-off region
• Saturation region
• Active region
• Inverted  region

For more study check the link below

• EXPLAIN FOUR (4) WAYS BY WHICH THE TWO JUNCTION OF A TRANSISTOR ARE BIASED
• Both Junction forward biased
• Both Junction reversed biased
• Base emitter BE forward biased, Base collector BC reversed biased
• Base emitter BE reversed biased, Base collector BC forward biased

For more study check the link below

• STATE TWO ADVANTAGES OF JFET
• Higher input impedance
• Low distortion OR generate less noise
• Higher resistance to nuclear radiation.

what are the advantages and disadvantages of jfet

For more study check the link below

• STATE THREE ESSENTIAL OF TRANSISTOR CIRCUIT
• Collector current must be zero
• Stability  
• The value for germanium must not be below 0.5v, and silicon must have an electron affinity of 4.05ev

For more study check the link below

• Identify two factors that affect the transistor
• Change in temperature
• Change in power supply 
• Ageing of component

• Identify ways of coupling a transistor.
• Transformer coupling
• Resistance or capacitance coupling 
• Inductance capacitor coupling
• Direct coupling

• WHAT’S FAITHFUL AMPLIFICATION: Faithful amplification is the raising of a weak signal without change in the shape of the signal.

Amplification factor: Raising the strength signal.

1. WHAT’S QUIESCENT POINT: Is the point of intersection between the D.C load line and the A.C load line. It can also be define as the point you get when you plot the collector current Ic, base current IB and the collector-emitter Voltage VCE in a graph. It’s also known as the operating point.

For any more question and in depths of solved past question on electronics or any past questions relevant to you, you can simply get it fast by visiting our site or visit our blog page for more post

You can also sign up for newsletter.

Link:     making school easy